Constant temperature shower installation

Constant temperature shower installation and use:

1. Users with small solid blocks in tap water are not suitable for using thermostatic sprinkling faucets;

2. If there is powdery precipitate or soft foreign matter in tap water, the sensitivity of thermostatic spool may be reduced, and the service life of thermostatic shower faucet may be shortened;

3. Try to shorten the distance between the water heater and the tap, so that the hot water can reach the tap as soon as possible;

4. Normal water pressure is 0.05mpa ~ 0.6mpa;

5. The cold and hot water supply pipes should not be installed incorrectly. The hot water pipe should be on the left side and the cold water pipe should be on the right side.

6. Be sure to clean up the installation site before installing the thermostat sprinkling faucet, so as not to damage the rubber ring, thread, thermostat spool and other parts of the faucet by small sand and stone blocks;

Thermostatic shower

7. Please install according to the instructions in the manual, pay special attention not to leak, lose or damage any gasket or rubber ring;

8. The constant temperature shower faucet itself has no heating function, please adjust the water temperature of the water heater to 60℃ ~ 85℃;

9. Shower and shower tube can not withstand the high temperature of more than 60℃;

10. After each use, please be sure to set the water temperature adjustment knob on the left below 40℃;

11. If the water pressure difference between hot water and cold water is too large, use a screwdriver to adjust the valve of the support. Households using gas water heaters need to pay more attention to this point.